HAND SWAGED DIY BALUSTRADE KITS

AUSTRLAIN BALUSTRADE REGULATIONS ARE THAT IF DECK / FLOOR HAS A FALL OF 1000mm OR MORE YOU ARE REQUIRED TO FOLLOW THE REGULATIONS INORDER TO HAVE A SAFE AND COMPLIANT WIRE ROPE BALUSTRADE. iF THE BALUSTRADE HAS A FALL LESS THAN 1000mm YOU ARE FREE TO DESIGN IT HOWEVER YOU LIKE.

HAND SWAGED DIY WIRE ROPE FITTING KITS.

EACK KIT COMES COMPLETE WITH ALL THE REQUIRED FITTINGS TO RUN AND TENSION 1 WIRE UP TO 6MTRS LONG.

YOU WILL NEED TO PURCHASE EITHER 7x7 OR 1x19 CONSTRUCTION WIRE ROPE SEPERATLY TO USE WITH THE KITS IN THIS CATEGORIE.          ALL KITS IS THIS CATEGORY REQUIRE THE USE OF A HAND SWAGING TOOL TO SWAGE THE WIRE ROPE FERRULES SUPPLIED IN THE KITS 

 REGULATIONS ARE THAT THE BALUSTRADE TOP RAIL OVERALL HEIGHT MUST BE A MINIMUM OF 1000mm HIGH. BASED ON USING 3.2mm WIRE ROPE THE WIRES MUST NOT BE SPACED ANY FURTHER THAN 80mm APART AND THE OPEN DISTANCE BETWEEN ANY TWO POSTS MUST NOT EXCEED 2000mm. WIRES CAN BE SUPPLIED PRE SWAGED UP TO 9 MTRS LONG.

IF THE FALL IS GREATER THAN 4000mm OR IT IS A POOL FENCE HORIZONTAL RUN WIRES ARE NOT PERMITTED BY THE REGULATIONS. WIRES MUST BE RUN VERTICALY AND SPACED AT 80mm. IF THE BALUSTRADE IS A POOL FENCE THE OVERALL HEIGHT OF THE TOP RAIL MUST BE NO LESS THAN 1200mm HIGH.

WE HAVE PROVIDED THE ABOVE INFORMATION AS A GUIDE ONLY AND CAN NOT BE RESPONSIBLE FOR ANY ERRORS IF ANY. WE RECCOMEND CONSULTING WITH A BUILDING CERTIFYER OR YOUR LOCAL COUNCIL BEFORE COMMENCING YOUR PROJECT


New Products For July - HAND SWAGED DIY BALUSTRADE KITS




Featured Products - HAND SWAGED DIY BALUSTRADE KITS