PRE SWAGED TO LENGTH WIRE ROPE FITTING KITS.

ALL KITS IN THIS CATEGORIE COME SUPPLY WITH THE WIRE ROPE (purchased seperatley) CUT TO LENGTH AND THE FITTING HYDRAULICY SWAGED TO THE WIRE ROPE.

TO MEASURE THE LENGTH THE THE WIRES WILL NEED TO BE YOU SIMPLY NEED TO MEASURE FROM THE INSIDE FACE TO INSIDE FACE OF THE END POSTS THAT THE WIRE WILL MOUNTED BETWEEN. YOU WILL NEED TO PROVIDE US WITH THIS MEASURMENT AND THE NUMBER OF WIRES REQUIRED FOR EACH MEASURMENT.

TO CALCULAT THE QUANTITY OF WIRE THAT YOU WILL NEED TO PURCHASE SIMPLY MULTIPLY THE MEASURMENT FRON INSIDE FACE - INSIDE FACE OF THE END POST BY THE NUMBER OF WIRES REQUIRED.

AUSTRLAIN BALUSTRADE REGULATIONS ARE THAT IF DECK / FLOOR HAS A FALL OF 1000mm OR MORE YOU ARE REQUIRED TO FOLLOW THE REGULATIONS INORDER TO HAVE A SAFE AND COMPLIANT WIRE ROPE BALUSTRADE. iF THE BALUSTRADE HAS A FALL LESS THAN 1000mm YOU ARE FREE TO DESIGN IT HOWEVER YOU LIKE.

IF THE FALL IS GREATER THAN 4000mm OR IT IS A POOL FENCE HORIZONTAL RUN WIRES ARE NOT PERMITTED BY THE REGULATIONS. WIRES MUST BE RUN VERTICALY AND SPACED AT 80mm. IF THE BALUSTRADE IS A POOL FENCE THE OVERALL HEIGHT OF THE TOP RAIL MUST BE NO LESS THAN 1200mm HIGH.

 REGULATIONS ARE THAT THE BALUSTRADE TOP RAIL OVERALL HEIGHT MUST BE A MINIMUM OF 1000mm HIGH. BASED ON USING 3.2mm WIRE ROPE THE WIRES MUST NOT BE SPACED ANY FURTHER THAN 80mm APART AND THE OPEN DISTANCE BETWEEN ANY TWO POSTS MUST NOT EXCEED 2000mm. WIRES CAN BE SUPPLIED PRE SWAGED UP TO 9 MTRS LONG.

WE HAVE PROVIDED THE ABOVE INFORMATION AS A GUIDE ONLY AND CAN NOT BE RESPONSIBLE FOR ANY ERRORS IF ANY. WE RECCOMEND CONSULTING WITH A BUILDING CERTIFYER OR YOUR LOCAL COUNCIL BEFORE COMMENCING YOUR PROJECT



PRE SWAGED TO LENGTH WIRE KITS










New Products For November - DIY WIRE ROPE BALUSTRADE KITS